1) Which of the following is the net requirement using an MRP program if the gross requirement is 10,000 and the inventory on hand is 4,000? 2) Which of the following is one of Dr. Eli Goldratt’s rules of production scheduling for optimized production technology? 3) Which is the one correct value stream principle? 4) Which production process term best describes the situation when activities in a stage of production must stop because there is no work? 5) Which of the following is an element that addresses elimination of waste under lean production? 6) Which of the following is an analytical tool used in Six-Sigma quality improvement programs? 7) Which of the following is usually included as an inventory holding cost? 8) Which of the following is a characteristic that can be used to guide the design of service systems? 9) Which of the following is considered an organizational blueprint, which prescribes the quantity and time frame for when each end product will be assembled? 10) There are many applications of poka-yokes in service organizations. Which of the following is one of the three-T’s used to classify poka-yokes? 11) The ability to rapidly and inexpensively switch production from one product to another enables which of the following: 12) Which of the following is a cost impact and payoff analysis tool from the operations consulting tool kit? 13) Which of the following is a major factor that distinguishes service design and development from manufacturing design and development? 14) In a Gantt chart the vertical axis represents which of the following? 15) A project can be segmented into which of the following?